Need help?Do you have a question about the Lifetime 60028 and is the answer not in the manual?
General| Brand | Lifetime |
|---|---|
| Model | 60028 |
| Category | Outdoor Storage |
| Language | English |
Details online registration benefits and warranty service access.
Key safety warnings and precautions for assembly and use to prevent injury or damage.
Guidance on checking parts, requiring adult assistance, and organizing for assembly.
Explains how to interpret manual symbols, sections, and identifiers for clarity.
Comprehensive list of main composter parts and hardware with quantities and identifiers.
Visual guide to identify main composter parts, showing appearance and quantity.
Visual guide for identifying all hardware, shown at actual size.
Connect Inner Legs to Outer Legs, then attach A-Frames, requiring two adults.
Fasten legs and A-Frames together using self-tapping screws for structural integrity.
Install the locking pin spring and attach the locking pin to the base frame.
Attach inner housing brackets to the A-frames using bolts and nuts.
Drill divots on end, front/rear, and top/bottom panels as instructed.
Insert blowhole plugs into manufacturing holes on the inside of all tumbler panels.
Secure warning-labeled mounting plates to end panels using bolts, washers, and nuts.
Fasten hinge pivots to each end panel, ensuring proper alignment and recess.
Assemble washers, sleeve, and bolt; apply grease to the sleeve for smooth operation.
Connect the end panel with the mounting plate to the base using the bolt assembly and spacer.
Align end panels, use locking pin, then attach the front/rear panel to the end panels.
Insert the ventilation tube into the ventilation holes in the end panels.
Insert ventilation tube bushings into end panels, aligning placement notch with the panel nub.
Secure the ventilation tube to its bushing using pan-head screws.
Attach hinges to the angled ends of a top/bottom panel using screws, washers, and nuts.
Place the tumbler upside down, align hinges with base pivots, and close the panel.
Align divots and fasten the bottom tumbler panel to the end panels with screws and nuts.
Connect hook straps to the notches of the bottom panel while the tumbler is upside down.
Secure hook straps to the rear panel using screws and plastic nuts.
Place the final top/bottom panel over the hinge pivots and close the top panel.
Attach latches to the front panel and secure them with screws and nuts.
Details the terms, conditions, limitations, and exclusions of the 5-year limited factory warranty.
Information on purchasing accessories or other Lifetime Products via website or phone.
To Next Page
