Lifetime 6417 - Page 101

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
101
SEC
18
18.1
18.1
18.2
AHT
SEC
SEC
:PVNBZOFFEUPBEKVTUUIFIFJHIUPGUIF$FOUFS%PPSUPFMJNJOBUFBOVOFWFOHBQ-PPTFOUIFUXP/VUTPOUIF
Hex Bolt on the Carriage Bracket to raise or lower the Center Door. Once the door has been adjusted to the
desired height, retighten the Nuts.
Adjust these nuts to raise
and lower the Center Door.
Carriage Bracket
Hex Bolt
If you plan on anchoring your shed to your platform, ensure your shed is in the position you would like it to
CFPOZPVS1MBUGPSN8IJMFBOPUIFSQFSTPOIPMETUIF4IFEJOQMBDFVTFBwNBTPOSZCJUGPSDPODSFUF
QMBUGPSNTPSBwESJMMCJUGPSXPPEFOQMBUGPSNTUPESJMMUISPVHIUIFIPMFJOFBDI-#SBDLFUBUUIFCPUUPNPG
FBDI8BMM4VQQPSU$IBOOFMBOEJOUPUIFQMBUGPSNCFOFBUIwEFFQ The anchoring hardware used depends
POZPVSQMBUGPSN*GZPVIBWFBDPODSFUFQMBUGPSNXFSFDPNNFOEVTJOHwYw$FNFOU4DSFXTFH
Tapcon Anchors. If you have a wood-framed platform, we recommend using 1/4” x 1” Lag Bolts. Do not exceed
a 3/8” diameter bolt. Use a hammer drill to insert the cement screws or a regular drill to insert the Lag Bolts.
Refer to your local hardware store for this hardware.:PVDBOBODIPSFBDI%PPS'SBNF4VQQPSU#SBDLFUTUPUIF'MPPS
VTJOHUXP1/4” x 5/8” Pan-Head Screws (ADZ)PSZPVDBOBODIPSFBDIPGUIFNUPZPVSQMBUGPSNVTJOHUXP
1/4” Anchor Bolts or 1/4” Lag Bolts. Do not exceed a 1/4” diameter bolt for the Door Frame Support Brackets. Refer to
your local hardware store for this hardware.
Door Frame Support Bracket
CENTER & LEFT DOOR ADJUSTMENT
ANCHORING SHED
18.1
18.2
5/16”Y
Note: Insert anchoring hardware through the Floor Brackets
(aht) attached to the bottom of each Wall Support.
!
ADZ (x4)
ADZ
3/16”