Lifetime 6417 - Page 83

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
83
SEC
ADX (x4)
AFF
AFF
Rear Gable
Front Gable
ADX
ADJ
AAK
14
Note: There are no pilot holes in the Gable to receive the Screws (ADX). Insert them directly into the plastic.
!
SEC
14.1
Install the Gable Truss Brace (AFF)CFUXFFOUIFFOE5SVTTBOEUIF3FBS(BCMF:PVXJMMOFFEUPSFNPWFUIF1/4” x 1
1/2” Hex Bolts (AAK) and the 1/4” NKE Cap Nuts (ADJ) from the bottom of the Truss Assembly, and then reattach to the
(BCMF5SVTT#SBDF$POOFDUUIF#SBDFEJSFDUMZUPUIF(BCMFXJUIUXP#10 x 1/2” Pan-Head Screws (ADX). Repeat
UIJTTUFQGPSUIF'SPOU(BCMFDPOOFDUJOHUIF(BCMF#SBDFUPUIFDFOUFSPGUIFUPQPGUIF%PPS)FBEFS$IBOOFM
with one (1) #10 x 5/16” Pan-Head Screw (ACF) and one (1) #10 Cap Nut (ADK):PVNBZOFFEUPTMJHIUMZBEKVTUUIF
(BCMF5SVTT#SBDF
GABLE BRACE INSTALLATION
ADK (x1)
ADK
ACF (x1)
ACF
WARNING
Do not overtighten the Cap Nut.