To Next Page

To Previous Page

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE

SEC

BAE

BAD

**TWO ADULTS REQUIRED FOR THIS STEP**

SEC

1.9

SEC

1.10

0LACETHE*#HANNELONTOTHETUBESOFTHETable Leg Assembly (BAE)ASSHOWN4ILTTHE"ENCHANDINSERTTHEOTHER

*#HANNELATTACHEDTOTHE"ENCHONTOTHE4ABLE,EG!SSEMBLY

0LACETHE*#HANNELBACKINTOTHE"ENCH%NSURETHE*#HANNELlTSINTOTHEGROOVEINTHE"ENCH)NSERTTHE

3CREWSBACKINTOEACHHOLEINTHE*#HANNEL!TTACHTHE3CREWINTHEMIDDLEOFTHE*#HANNELlRST5SETHESAME

HOLESINTHE"ENCHFROMWHICHTHE3CREWSWEREREMOVED4IGHTENTHE3CREWSONLYUNTILTHEHEADOFTHE3CREW

MAKESCONTACTWITHTHE*#HANNELRepeat Steps 1.8 through 1.10 to attach the other Bench.

USE HARDWARE TAKEN FROM J-CHANNEL

Note: Do not put the J-Channel on upside down. Refer to the installed J-Channel for the correct orientation.

Lifetime 80123 User Manual

Other manuals for Lifetime 80123