Lifetime 90136 - Section 1.2: Second Joint Assembly

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
12
SEC
1.2
ASEX
ARN X
3/16”
Attach a Light Brown Tube (CPD) to the bottom of the assembly completed
in the previous step (Joint A). Slide a vXv"OLT!2. through a
Washer (ARL)ANDTHETWO,IGHT"ROWN4UBES0LACEA7ASHER over the
"OLTANDlNGERTIGHTENANylock Nut (ASE) for removal later. Follow the
SAMEASSEMBLYFOR*OINT"
*OINT!
*OINT"
CPD
ARL X
ARN
ASE
ARL
ARL
Note: Repeat this step on all five assemblies.
!
1/2”