Lifetime 90136 - Section 1.7: Adding Sticked Tubes

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
17
6
5

1
2
3
Remove the 5/16” Standard Nut (ATL), the Washers (ARL) and the v
Bolt (ASI) at Joint C and add an additional Light Brown Tube with Sticker
(CPE)2EPLACETHE7ASHER.UTAND"OLTHOWEVERDONOTCOMPLETELY
tighten to Joint D, repeat the same process for Joint E.
2EMOVETHEHARDWAREAT*OINT%0LACETHEREMOVED"OLTAND
7ASHERTHROUGHTHEADDED,IGHT"ROWN4UBESWITH3TICKERS#0%
and 'REEN4UBEWITH3TICKER#0& in the order indicated. Replace the
HARDWAREANDTIGHTENJOINTCOMPLETELY#OMPLETEAROUNDTHECIRCLE
SEC
1.7
3/16”
1/2”
*OINT$
*OINT%
*OINT&
#0&
CPE
CPE
ATL
ARL
ARL
ASI
NO NEW HARDWARE REQUIRED
&/24()30!'%