10. Operation
In normal operating conditions, the StairTrainer should always be connected to a 100-240 V
socket.
10.1 Calibration after power failure/disconnection
If the power supply has been interrupted, or if the system registers any other irregularity, the
training aid must be calibrated
Run the training aid down until it rests on the
lower level (10 cm). Release the arrow key.
Press and hold the arrow key () for a
minimum of 4 seconds. The calibration is
complete when the display shows E01.
IMPORTANT!
If the training aid does not operate as expected or stops again after a few centimetres,
technical problems may have arisen and require a repair by technical staff. Contact
your dealer for further assistance.
11. Maintenance
Clean by wiping off with a cloth that has been wrung out in water containing a mild detergent.
IMPORTANT!
Do NOT use a high-pressure cleaner or wash the StairTrainer down with water straight
from a hose. Aggressive detergents and suchlike must not be used on the device. Also
avoid salt or sand coming into contact with the training aid in connection with winter
maintenance.
The mechanical maintenance of the StairTrainer is normally only undertaken in connection the
regular service inspections which must be carried out by and authorized service technician. In
the event of unintended errors or dissonance, contact your dealer immediately for assistance.
IMPORTANT!
Perform regular checks under the device for any items/objects and remove these in
order to ensure free movement of the training aid.
To Next Page
