7. Function description
The StairTrainer is a so-called “dead man’s switch” device, i.e., the push buttons must be held in
throughout the entire operation. The training aid is easy to operate: The user chooses whether
the stairs should move upwards or downwards by pressing one of the push buttons on the
operating panel.
The StairTrainer can be moved around by one person thus allowing for use in multiple locations.
8. Start-up
The StairTrainer must always be connected to a 100-240 V socket and be switched on. Normally,
the StairTrainer is always in “standby mode”, i.e. it is ready for use as soon as one of the
operation keys is pressed.
If the power supply has been interrupted, or if the system registers any other irregularity, the
device must be calibrated, cf. section 10.1.
9. Instructions for the use
The StairTrainer is activated and operated by
means of the arrow keys on the operating
panel.
UP arrow ():
Moves the training aid upwards
DOWN arrow ():
Moves the training aid downwards
Height adjustment
It is easy to adjust the height of the StairTrainer
to match the current need: Press and hold the
appropriate arrow key to run the training aid
up or down. Release the button once you have
reached the required height.
The display always shows the current height
(cm) between the floor and platform/top step.
To Next Page
