LIGHT MY BRICKS LEGO LOOP COASTER - Page 29

LEGO LOOP COASTER 10303 LIGHT KIT INSTALL GUIDE
INSTRUCTIONS 29
Legend
DISCONNECT
CONNECT /
RECONNECT
TURN / FLIP DIRECTIONAL TWIST / BRAID POWER ON TEST NOTE ICON
20
Connect the other
end to a 5V USB
Power Bank, 5V USB
Wall Adaptor, or USB
to AA Battery Pack
(sold separately)
USB Power Cable
2x Adhesive Squares
Thread the 50cm
Connecting Cable
through the rings as
shown
Run the USB
Power Cable back
inbetween the studs
If you experience any issues with the lights not working and suspect an issue with a component, please try a dierent port on the expansion board to verify where the fault lies (with the light or
expansion board). To correct any issues with expansion board ports, please view the section addressing expansion board issues in our troubleshooting section.