EasyManua.ls Logo

Light4Me SPARK V2 - 4.3 DMX Channel Description; 4.4 Connection to the Mains; 4.5 Notes Before Use

Light4Me SPARK V2
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Content displayed
expression
【Ready To Work 】
It means that the machine is ready and can be sparkled at any time.
【Warming Up...... 】
It means that the machine is being heated.
【DMX512 Add.xxx 】
Set DMX512 address: minimum 1, maximum 512
【Volume Out xxx %】
Set the amount of sparkle: minimum 1%, maximum 100%.
【Tip Over】
Dumping alarm, setting if to alarm when the inclination is less than
45 degrees.
【Manual Test】
Manual switch sparkle, only for testing.
4.3 DMX Channel Description:
When using the DMX mode, two channels are occupied:
First channel
Function
0
Spark effect off
1-255
Spark effect on
Second Channel
Function
0-20
Pre-heat off,And the first channel is invalid
50-100
Pre-heat on,And the first channel is valid
150-200
Clear Material,And the first channel is invalid
The priority relationships: DMX, Remote controller.
4.4 Connection to the mains
Connect the device to the mains with the power plug .The jack POWER OUT allows for power supply
of further devices .To interconnect several devices ,connect the jack POWER OUT to the input POWER
IN of the next unit all units are connected .Matching power cables with P-Con plugs are available as
accessories.IN this manner, up to 3 devices can be linked
4.5 Notes before use :
1. Place the sparking machine horizontally, and inspect for damaged at each use. If damaged, please
contact us for service. Unscrew the lid of powder tank to pour in the our powder, and then lightly
tighten the lid.
2. Before power on, please verify that the supply voltage is in conformity with the rated voltage of the
sparking machine. At power on, the machine will begin to heat for use .Connect the machine to your
selected controller.
3.The machine must be used only in a well ventilated place but not where is air flow if limited or the
machine’s thermal protection system may cause a shutdown.
Light4Me SPARK V2 - 4.3 DMX Channel Description; 4.4 Connection to the Mains; 4.5 Notes Before Use