Wireless controller pairing:
One machine can pair with up to 5 controllers.
Here are steps to pair with new controllers:
S
tep 1: Power on machine, disconnect DMX connection. Connect receiver to the 5-pin socket.
Press MENU key to navigate to [r---], and set it to [r on] to enable wireless control.
S
tep 2: Press MENU key to navigate to DMX address menu [d---], now long press MENU key,
machine will enter wireless controller registering mode, and display [rEg-]/[rEg.-], it will last 10
seconds.
S
tep 3: Within 10 seconds, press any buttons of new controllers, the display will change to
[rEgx], the last digit x is the number of controllers currently registered, it can be 1-5.
Step 4: after 10 seconds, display will show [donE], registering mode exit, session finish.
No
te1: In a session, registering the sixth controller will be treated as a new first one, and make
the former 5 registered controllers become unregistered!
Note2: In a new session, if new controller being registered, the controllers registered in last
session would become unregistered, so to add new controllers, you need to register old
controllers in a same session too.
To Next Page
Loading...
