What to do if Lightmaxx LED RGB Color Bar Stripe has no reaction in DMX mode?
If your Lightmaxx DJ Equipment isn't reacting in DMX mode, first verify the cable connections. Then, check your DMX address settings. If possible, test with another DMX controller.
General| Brand | Lightmaxx |
|---|---|
| Model | LED RGB Color Bar Stripe |
| Category | DJ Equipment |
| Language | English |
Warning about electric shock and the prohibition of opening the device.
Explanation of lightning flash and exclamation mark symbols.
Device for indoor use only; avoid moisture, heat, dust. Recycle packaging.
Adapt to ambient temp, ventilate, disconnect when unused, max 40°C temp.
Installation by qualified personnel only; observe load limits and safety.
Dangers for babies and children regarding packaging and unattended use.
Warning against opening the device due to high internal voltage.
Prohibition of modifications to cable/plug to prevent shock/fire.
Avoid direct viewing of the light source to prevent eye injuries.
Warn sensitive people about stroboscopic effects causing seizures.
Keep away from heat sources and open fire; do not block vents.
General guarantee conditions from Music Store professional GmbH.
List of items included with the product.
Specifies the product's intended application and user requirements.
Device for indoor use; avoid rain, moisture, dirt, sunlight.
Match voltage, use RCD, disconnect when not in use.
Check for damage, use secure mounting, create safeguard, work safely.
Note that the device cannot be used with a dimmer.
Ensure compliance with standards and secure with a second cable.
Ensure adequate ventilation and stay within 40°C ambient temperature.
Ensure stability and do not exceed tripod load capacity.
Do not connect DMX to audio devices; use proper DMX cables.
Make all connections before switching on; use short, high-quality cables.
Details on DMX connector pinout and 120 ohm resistor.
Connect DMX controller, use 110 Ohm cables, set DMX address via DIP switches.
Device features automatic programs or sound-activated modes via built-in microphone.
Configure master unit and slaves using DIP switches for synchronized operation.
Recall built-in programs and control speed/effects using DIP switches.
Activate sound control and adjust sensitivity via DIP switches.
Set DMX address using DIP switches 1-9 with Dip 10 enabled.
Details on LEDs, color, voltage, power consumption, dimensions, and weight.
Guidance for 'No function' and 'No reaction in DMX mode' problems.
Proper cleaning of the device using a dry microfiber cloth and compressed air.
Recycling packaging, proper disposal of batteries and old devices (WEEE).
To Next Page