6
• Start with the LightningAir on its lowest Square Feet setting and turn the
Ozonator dial “up” as necessary. The ideal amount of activated oxygen will leave
your room smelling clean and fresh. If the unit is set too high, you will smell the
ozone. If it set too low, you will smell household odors.
• The Ionizer is designed to run independently from the activated oxygen produc-
tion. The ionizer can be used around the clock to keep down dust and particulate.
Ozone, however, should be kept at modest levels in occupied spaces. Ozone’s
primary application is to control odors. The level of ozone may be adjusted accord-
ing to the severity of the odors in the home or office. Many users put the purifier on
a timer so it can run at high levels while being away. The timer is set to cut off about
one hour before the occupants are scheduled to return. The O
3
that is not used
normally reverts back to O
2
in about an hour. When they arrive the air is fresh
and clean.
• Individual sensitivity to activated oxygen and preference may vary and should be
adjusted accordingly. The effect of activated oxygen on indoor air may vary accord-
ing to atmospheric and/or environmental conditions such as altitude, humidity, air
movement, severity of existing odors, house design, and square footage.
• If you desire to treat the entire home with the same level of ozone, set the fan
switch on your home’s heating & cooling system to the ON position rather than
AUTO. Open all interior doors and adjust the activated oxygen level to the appropri-
ate square footage. Then place the unit so the air from the purifier flows directly into
a air return vent.
• Altitude: Generally, in higher altitudes the requirement for activated oxygen
decreases. Therefore, higher altitudes should require lower settings.
• Humidity: Generally, in higher humidity the requirement for activated oxygen
increases. Therefore increased humidity may require higher settings.
• For optimal treatment of air in your designated area, your new air purification unit
should be placed in a central location (higher is better). Your unit can be set on a tall
piece of furniture. Allow three inches between the back of your unit and the wall to
allow proper airflow. Fan speed is normally set in the medium range. The reason for
elevated placement of the unit is that activated oxygen is heavier than air. Elevated
placement allows for better circulation. It is suggested that the purifier be placed in
the room that is close to the primary source of odor.
Operation / Installation
To Next Page
Loading...