36 NO DMX SCN?
A scene or chase program selected here will be output if the DMX fail option, menu 33, is set to ‘Go No
DMX’, DMX is a selected input type and the DMX signal fails or is missing.
361 [ ]
∧∧/∨∨to select scene or chase and press 4. ⇒STORED OK
4 SET SUPPLY?
Press the 4 - the display will show
41 SET PHASES ?
Press the 4 - the display will show
411 ORDER []
Default = [aut]
Pressing the up or down arrow keys will change the setting within the square brackets on the display.
Subsequent presses will display the different settings available, these are:-
[111]Single phase
[123]3 Phases connected in the order 1,2,3
[132]3 Phases connected in the order 1,3,2
[aut]Auto phase order detection
Change to the desired option and press 4 to select and memorise the setting. ⇒STORED OK
42 SET FREQ?
Press 4.
421 FREQ [auto]
Default = [auto]
∧∧/∨∨to select [50Hz], [60Hz] or [auto].
Press 4 to select and memorise the setting. ⇒ STORED OK
5 SET INPUTS?
You may select the input signal type used to control the dimmer from the following list. Where there is more than
one input signal source selected, the highest level received by any channel will be used (HTP)
Press 4.
51 [ ]
Default = DMX+Analog.
Choose from: DMX only, ANALOG only, DMX+ANALOG, WP6, WP9.
Menu Functionality
Description
DMX only DMX input only active
Analog only Analogue input only active
DMX+Analog DMX and analogue inputs mixed on
HTP basis
WP9+DMX Six 0-10V inputs have control over
each scene - any/all scenes can be
mixed on an HTP basis
WP6 + DMX Latching scene control input for use
with 6-button panel. Mixed with
DMX input on HTP basis
WP6 + CONT WP6 swaps with DMX according to level of
seventh channel.
DMXAnalog Analogue output if no DMX.
WP6M Level control of four scenes.
See page 5 for fuller explanations of of the various inputs.
∧∧/∨∨to select option and press 4 to store. ⇒ STORED OK
LightProcessor Paradime, all variants, version 21, September 2003
Page 8
MENU SYSTEM AND USER OPTIONS - cont’d
To Next Page
Loading...