LightProcessor PARADIME - Specification

Power Requirements Voltage 230V AC nominal. (194-264V AC)
Link selectable to 115V AC nominal. (100-120V)
Frequency 48-62Hz.
Three phase + neutral + earth
Single phase + neutral + earth with links fitted (10A per channel models only)
Dimming Capacity Six channels of dimming per dimmer unit.
Maximum load: 10A models 10A per channel/60A total.
16A models 16A per channel, 3-phase only
32A per phase. 96A total.
20A models 20A per channel, 3-phase only
40A per phase. 120A total.
25A models 25A per channel, 3-phase only
25A per phase. 75A total (3-channels).
Minimum load: All models 100W per channel
Control Inputs Analogue 0 to +10V, via 8-pin locking DIN.
20kOhm input impedance
USITT DMX512 (1990), via 5-pin XLR.
Output Connectors Power output connectors are available covering a range of
international standards.
Hardwired versions are also available with screw terminal connectors.
Phantom Power Output 16V DC unregulated and current limited by 100mA self-resetting fuse.
Physical Characteristics Weight: between 11 and 14Kg., depending on model and rating.
Dimensions:Rack models
Height: (depending on model) 2, 3 or 4 rack units.
Width: 19 inch rack mounting
Depth: 360mm. (excluding any output sockets)
10Amphardwired, hardwired D/P.
Sockets:- 6 x Schuko, 6 x French, 6 x US
6 x Swiss, 6 x UK (15A), 6 x CEE17, Patchpack
12 x Schuko, 12 x French, 12 x UK (15A)
16Amphardwired, hardwired D/P.
Sockets:-6 x Schuko, 6 x French, 6 xCEE17,
12 x Schuko, 12 x French, Patchpack
20Amphardwired. Sockets:- 6 x Japanese C-type
25Amphardwired.
Wall models
Height: 455mm.
Width: 335mm.
Depth: 105mm.
10Amphardwired, Sockets:- 12 x UK (15A)
16Amphardwired
Other versions may be available to special order.
Environment Temperature 0-30°C
Relative humidity 0-90% non-condensing
Pollution Degree 2
Protection ClassificationIP30
Conformance All Paradimes are designed to meet CE regulations covered by:
LVD (using EN60439 and EN60950)
EMC (EN55014 and EN50082-1)
LightProcessor Paradime, all variants, version 21, September 2003
Page 15
SPECIFICATION