NOTE: Reliable range of remote operation is around 15 metres indoors and
up to 100m outdoors using the Lightwave Link. This figure may vary
depending upon the environment; very thick walls, bodies of water or
large metal objects may interfere with radio range.
If the distance between the transmitter and receiver is too great to achieve
reliable operation, the LightwaveRF Signal Booster may be used in
conjunction with this product to increase the range.
IMPORTANT: Inline relays should not be positioned within 30cm of one
another, as their transmition signals may interfere and reduce the eective
operational range.
Clearing the memory (will remove any linked App or Controllers):
1. On the relay, press and hold down the
linking button until the LED flashes, and
then release it. That relay is now in
linking mode.
Device setup
2. Press and hold down the linking button again until the LED flashes more
quickly, then tap (don’t hold) the linking button a further time; the LED will
flash slowly to confirm that the memory has been cleared.
Linking
button
To Next Page
Loading...