Fan on during〖Air
exhausting time, F5〗
Fan on, because of temperature and humidity protection exhaustion.
Egg-turned-counter has reached〖Egg turn times, F3〗
Egg-turned-counter has reached〖Egg turn times, F3〗
Room temperature or humidity is over warning points, or sensor fails
Warning code
Temperature sensor failure
Room temperature is higher than〖High temperature warning point, P0〗
Room temperature is lower than 〖Low temperature warning point, P7〗
Room humidity is higher than〖High humidity warning point, P8〗
Room humidity is lower than〖Low humidity warning point, PP〗
Wiring Diagram
Attention
The device is shipped with factory default
setting. It suits for normal hatching
requirements. It is even able to use
directly without any setting for other
parameters. About factory default setting,
see the tables above.
If need to set new temperature and humidity, please operate according to paragraph “Set temperature and humidity
set-point”. The Temperature and humidity control parameters will be generated automatically and accordingly.
If you try to set the Temperature and humidity control parameters, please set them based on understanding to avoid
hatching failure.
Humidity sensor will not work correctly when covered with dust, water or dew. Please keep it clean and dry.
The sensor is suitable to working within 20% to 80%RH.
Before clean sensor, be sure there is no static electricity in hands!
Manufacturer is responsible for the device itself, is not responsible to losses resulted by the failure of this device.
LED indication
To Previous Page
Loading...
Need help?
General
