LIMITLESS PowerTrio - User Manual

PowerTrio– User Manual
Safety Information
By using the PowerTrio, you hereby agree that Limitless Innovations, Inc., an Illinois
corporation and its affiliates (“Limitless”) shall have no liability for any losses associated
with property damage, personal injury or loss of life that are incurred by you or by any
third party in connection with or relating in any manner whatsoever to your use of the
PowerTrio. By using the PowerTrio, you hereby agree a t all times to comply fully with all
safety warnings, operating instructions and general safety information in this user
manual. By using the PowerTrio, you further agree to hold harmless Limitless, (and
Limitless’ officers, directors, shareholders and employees) in connection with any losses
sustained by you (including, without limitation, losses arising in whole or in part from
property damage, personal injury or loss of life) relating in any manner whatsoever to
your use of the PowerTrio.
Warnings
• The PowerTrio is NOT a toy and should be kept away from children.
• Do NOT use the PowerTrio near a magnetic or electric field.
• Do NOT use the PowerTrio in direct sunlight or extreme heat for extended periods of
time.
• Do NOT use the PowerTrio if it has been damaged and/or modified.
• Do NOT subject the PowerTrio to harsh chemicals.
• Do NOT submerge the PowerTrio or its accessories in water.
• Do NOT store the PowerTrio where temperatures will exceed 140° F (60° C).
• Do NOT insert any foreign objects into the openings or port of the PowerTrio.
• Do NOT attempt to disassemble, repair, or open the PowerTrio or its accessories in any
way.
• Do NOT paint or apply coatings to the PowerTrio as you might affect moving parts or
damage internal components.
• Batteries should be recycled or disposed of, as per state and local guidelines.
What’s Included

Summary

Safety Information

General Safety Warnings

Key safety precautions and warnings for operating the PowerTrio, including not treating it as a toy and avoiding certain conditions.

Whats Included

Technical Specifications

How to Use

Setting Up the PowerTrio

Connect the PowerTrio using the Type-C to USB cable and USB wall adapter.

Setting the Clock

Instructions to set the time, including switching between 12-hour and 24-hour formats.

Setting and Using Alarms

Guide to activate, deactivate, set times, and check the configured alarms.

Turning Off the Alarm

Procedures for snoozing or deactivating the alarm when it rings.

Adjusting Brightness

How to increase or decrease the display brightness.

Charging a Mobile Device

Instructions for charging devices via wireless charging or USB port.

Using the LED Light

Guide to operating the LED light, cycling through modes, and turning it off.

Backup Battery Function

Explanation of the CR2032 coin battery's role in preserving settings during power outages.

Overview

1. Function Description
2. Important Technical Specifications
3. Usage Features
4. Setting Up
5. Setting the Clock
6. Setting & Using the Alarm
7. Checking the Alarm Setting
8. Turning Off the Alarm
9. Adjusting the Brightness
10. Charging a Mobile Device
11. Using the LED Light
12. Maintenance Features
13. Backup Battery
14. Safety and Care Warnings

The PowerTrio is a multi-functional device that serves as an alarm clock, wireless charger, USB charger, and LED night light. It is designed to be a versatile bedside companion, offering various features for convenience and utility.

Function Description:

The PowerTrio primarily functions as a digital alarm clock with two independent alarm settings. It also integrates a wireless charging pad for compatible mobile devices and a USB-A output for charging other gadgets via a cable. Additionally, it features an LED light with multiple color modes, which can be used as a night light or for ambient illumination. The device includes a backup battery to maintain alarm settings during power outages, ensuring reliability.

Important Technical Specifications:

• Model: LIM-PTRIO-XXX
• Backup Battery: CR2032 Coin Battery (pre-installed)
• Night Light Source: LED
• Time System: Supports both 24-Hour and 12-Hour formats.
• Clock Brightness: Adjustable with Max, High, Mid, and Low settings.
• Type-C Input: 5V/3A | 9V/3A | 12V/2A (for powering the device)
• Wireless Output: 5W, 7.5W, 10W, 15W (for wireless charging)
• USB Output: 5V/2A (for wired charging)
• Size: 5.51" x 4.61" x 2.87"
• Weight: 0.485 lb

Usage Features:

Setting Up:

To set up the PowerTrio, plug the provided Type-C to USB Cable into the USB Wall Adapter and then into the device's Type-C Input. The digital display will cycle upon connection.

Setting the Clock:

1. When the colon (":") on the display is blinking, press the Alarm Button twice slowly to switch between 12-hour and 24-hour time systems. The display will show "12hr" for the 12-hour system, along with AM/PM indicators. A short pause between clicks is recommended for this "double click" action.
2. Press the Alarm Button once to enter the minute setting. Use the Plus (+) and Minus (-) Buttons to adjust the value.
3. Press the Alarm Button again to enter the hour setting. Use the Plus (+) and Minus (-) Buttons to adjust the value.
4. Press the Alarm Button one more time to finalize the time setting; the colon will then flash. Note: If in time setting mode with flashing minutes or hours, press the clock button until only the colon is blinking to return to the main screen before attempting to switch time systems.

Setting & Using the Alarm:

1. To activate or deactivate Alarm 1, press and hold the Plus (+) Button for 3 seconds. To activate or deactivate Alarm 2, press and hold the Minus (-) Button for 3 seconds. The corresponding Alarm Indicator icons will illuminate when activated.
2. While an alarm is activated, press and hold the Alarm Button for 3 seconds to enter the alarm time setting mode. Follow the same steps as "Setting the Clock" (steps 2-4) to set the desired alarm time for both Alarm 1 and Alarm 2.

Checking the Alarm Setting:

1. First, activate the alarms you wish to check (as described above).
2. Press and hold the Alarm Button for 3 seconds to enter the alarm time setting mode. This will display the set time for Alarm 1 first.
3. Press the clock button repeatedly to cycle through and display the set times for:
   • Alarm 1 – Minutes
   • Alarm 1 – Hours
   • Alarm 2 – Minutes
   • Alarm 2 – Hours

Turning Off the Alarm:

The alarm will ring for 3 minutes before automatically shutting off.

1. Press any button to enter Snooze Mode. The Alarm Indicator will flash, and the alarm will ring again after 5 minutes. Snooze mode can be activated twice.
2. To turn off Snooze Mode and deactivate the alarm completely, press and hold either the Plus (+) or Minus (-) Button.

Adjusting the Brightness:

The default display brightness is set to maximum.

• Press the Minus (-) Button to decrease the brightness.
• Press the Plus (+) Button to increase the brightness. Brightness modes include Max, High, Mid, and Low.

Charging a Mobile Device:

1. Wireless Charging: Place a compatible mobile device on top of the Wireless Charger. The Wireless Indicator Light will illuminate upon a successful connection.
   • Wireless Indicator Light Status:
     • Successful: Blue Light Flashes Once
     • Standby: Light Off
     • Charging: Blue Light On
     • Charged: Light Off
     • Error: Blue Light Flashes Continuously
2. Wired Charging: Plug a USB cable into the USB-A Output port on the PowerTrio and connect the other end to your device. The device will begin to charge.

Using the LED Light:

1. Press the Light Button once to turn on the LED Light. It will initially turn on in White Light Mode.
2. Single-click the Light Button repeatedly to cycle through the 9 available light modes:
   1. White
   2. Alternating Colors
   3. Red
   4. Orange
   5. Yellow
   6. Green
   7. Blue
   8. Dark Blue
   9. Pink
3. To turn off the LED Light without cycling through all modes, press and hold the Light Button.

Maintenance Features:

Backup Battery:

The CR2032 Coin Battery is pre-installed in the Backup Battery Slot. This battery ensures that alarm settings are saved in the event of a power outage, maintaining the device's functionality.

Safety and Care Warnings:

• The PowerTrio is not a toy and should be kept away from children.
• Avoid using the device near magnetic or electric fields.
• Do not expose the PowerTrio to direct sunlight or extreme heat for extended periods.
• Do not use the device if it has been damaged or modified.
• Do not subject the PowerTrio to harsh chemicals.
• Do not submerge the PowerTrio or its accessories in water.
• Do not store the PowerTrio in temperatures exceeding 140° F (60° C).
• Do not insert foreign objects into any openings or ports.
• Do not attempt to disassemble, repair, or open the PowerTrio or its accessories.
• Do not paint or apply coatings to the PowerTrio, as this may affect moving parts or damage internal components.
• Batteries should be recycled or disposed of according to state and local guidelines.

LIMITLESS PowerTrio Specifications

General

Brand	LIMITLESS
Model	PowerTrio
Category	Alarm Clock
Language	English