Linak Techline Linear Actuator Technology - Page 12

12
Facts:
• For all actuators with limit switches
• Easy operation of actuators
without use of further electronics
• IP 66 for outdoor use
• Easy to install
• Tested with an LA36 12 V DC
for 50,000 operations
(*)
ROCKER SWITCH
Facts:
• Variable power supply 12-36 V DC
• Overload protection - adjustable
current limit 1-20 A
• Adjustable soft start and stop
• Several versions for different
applications
• Integrated brake
(*)
ACCESSORIES
MOTOR CONTROLLER
Facts:
• Protects the inner tube against
dust and dirt
• Can be used for actuators: LA22,
LA28, LA30, LA31, and LA32
• Does not change the IP rating
• Available in black colour
• Ask for special folder
(*)
BELLOW
Facts:
• Gives a better protection and
therefore gives a higher liftetime
of the actuator
LA30 WITH BELLOW
For detailed information - please use data sheets
Specifications subject to change without prior notice.
Facts:
• Synchronized parallel control for
2 Actuators
• Operates with pulse feedback
(Hall or Reed)
• Current and temperature limited
• soft start/stop
• Adjustable drive speed
• Accurate repeatability
• Easy setting via serial interface
(*)
PARALLEL CONTROLLER
Facts:
• 150 VA
• Primary 230 V 50/60 Hz
• Secondary 24 V max 6,8 A
• Prepared for build-in motor
controller or parallel controller.
• IP 66 housing for outdoor use
(*)
TRANSFORMER SOLUTION
(
*
) “The specifi ed product is a third
party product that is produced
by third party and distributed
by LINAK as a supplement to
LINAK´s existing product range. It
is the responsibility of the product
user to determine the suitability
of the product for a specifi c
application. LINAK will at point of
delivery replace/repair defective
products covered by the warranty
if promptly returned to LINAK.”