IS 713 ECN 4386 Page 7 of 11
The backlight adjustment screen is displayed next. Press the power button to cycle
through the values 1 to 25. Press the Set button to select the required value.
The contrast adjustment screen is displayed next. Press the power button to cycle
through the values 35 to 60. Press the Set button to select the required value.
Press the power button to exit.
Standby
If the appliance is to be left unused for any length of time, turn the element off by
pressing the power button.
Filter replacement
The filter display shows the estimated life left in the filter cartridge (Fig 3). A
reminder message is displayed when the filter needs changing.
Use of genuine
Fig 3
To replace the filter
Twist the base of the filter 90 degrees to the left and carefully lower the filter
cartridge out of the appliance. It will contain a small volume of water.
Re-insert new filter into the recess and lock into place by twisting to the right.
Press and hold both Set and Power button for 5 seconds to reset the filter life.
Drain off approximately 3 litres of water to remove any loose carbon particles from
the filter.
The boiler will not fill if the filter is removed as the filter head incorporates a shut-off
valve.
To Next Page
Loading...
