Lincoln LS 2002 - Lightsvertical Aim Adjustment; Turn Signal Control

Vertical aim adjustment
1. Park the vehicle on a level
surface.
2. With the hood open, remove
protective cover, then locate the
bubble level and the vertical
adjustment screw.
3. The numbers shown on the vial
indicate the directional change (up
or down) of the vertical aim.
4.Usea4mmwrench or socket to
turn the vertical adjusting screw
until the bubble is below the “0”
mark position when viewed directly
from above.
5. Install protective cover.
When the horizontal and vertical indicators are set to the “0” mark, the
headlamp has been properly aimed.
TURN SIGNAL CONTROL
• Push down to activate the left
turn signal.
• Push up to activate the right turn
signal.
• In DRL equipped vehicles, use of
the turn signals will shut off the
highbeams in daytime driving.
UP
D
INT
INT
OFF
AUTO
Lights
62