Lind Equipment Static Sure - Step 4: Operation

OPERATING MANUAL
STEP 4: OPERATION
Once the device has been assembled, set up, and tested, it will be ready for use.
+ One end of the assembly will be attached to the known ground point or the first
object, as per STEP 2.
+ The other end of the assembly can now be attached to the equipment that you
wish to ground or bond to using the hand clamp (FIGURE 5).
+ You must ensure that good metal to metal contact is made between the object
and the points of the clamp.
+ This connection should always be made prior to beginning the transfer process to
ensure that no flammable gasses are in the environment until after the connection
is made.
HOW TO USE THE StaticSure
If the warning light does not come on following the connection:
You have a safe connection and can proceed with your operation.
If the warning light starts blinking following the connection, take the following actions:
1. Check the assembly to ensure that all cables are properly fastened per instructions
in STEPS 1 and 2.
2. Ensure that there is proper metal to metal contact on the attached end.
3. Ensure that the item you are attempting to bond is electrically conductive
(i.e metal).
NOTE: Plastic totes, drums or barrels generally cannot be grounded.
4. Ensure that the points of the clamp have penetrated any paint, rust or other
debris which may inhibit metal to metal contact between the points on the
clamp and the item you are grounding.
5. If problem persists, contact your distributor or Lind Equipment.
HOW TO USE THE StaticSure
STEP 4: OPERATION (continued)
8 LIND EQUIPMENT LTD. T: 877.475.LIND www.lindequipment.net LIND EQUIPMENT LTD. T: 877.475.LIND www.lindequipment.net 9
FIGURE 5
FIGURE 5