Linde 115 Series - Page 7

Table of Content
Page 5
Service Training
RP01 / Chapter 1
115 804 2401.0304
09.06
6.2.8 Hydraulic enable signal 47
6.2.8.1 Hydraulic release signal 47
6.2.9 Hydraulic power supply 48
6.2.10 Hydraulic control circuit 49
6.2.10.1 LLC Voltage supply 49
6.2.11 Joysticks 50
6.2.11.1 Single axis lever bracket and connector positions 52
6.2.11.2 Dual axis lever bracket and connector positions 52
6.2.11.3 Joystick 53
6.2.12 Joystick operation lift / lower 54
6.2.12.1 Lift / lower operation 54
6.2.12.2 Lift 54
6.2.12.3 Lower 54
6.2.12.4 Joystick operation reach out/reach back 55
6.2.12.5 Joystick operation tilt / sideshift 56
6.2.12.6 Joystick operation for auxiliary 1 and 2 functions 57
6.2.12.7 UPA Joystick operation for clamp rotate 58
6.2.13 Reach slowdowns 09.03 59
6.2.13.1 Reach position value 09.03 59
6.2.13.2 Reach limits 09.03 60
6.2.13.3 Reach mechanical adjustments 09.03 60
6.2.13.4 Reach sensor operation 09.03 60
6.2.14 Hydraulic speed sensor 2B8 09.03 61
6.2.14.1 Hydraulic speed sensor function test 09.03 61
6.2.14.2 Hydraulic speed sensor output signal. 09.03 61
6.2.14.3 Hydraulic speed sensor setting 2B8 09.03 61
6.2.15 Lift stop sensor 09.03 62
6.2.16 Lock valve operation 03.04 63
6.3 Steering system (LES) 09.03 64
6.3.1 LES Circuit diagram 09.03 65
6.3.2 Steering safety sensors 09.03 65
6.3.3 Steering wheel unit 09.03 67
6.3.4 Steering force feedback 09.03 68
6.4 Driver’s display (LID) 09.03 69
6.4.1 Display indicators 09.03 70
6.4.2 Mode indicators & height commands 09.03 71
6.4.3 Display functions 09.03 71