Why is the wire live before welding with my Linde Welding System?
If the wire is live when feeding through the cable and torch before welding with your Linde Welding System, the issue could be a faulty wire inch switch or inappropriate use of the torch trigger switch. Check the wire inch switch functionality and user practice.
Why is there wire slippage with my Linde BOC Smootharc Advance MIG 200C?
If you experience wire slippage or deformation with your Linde Welding System, it could be due to incorrect feed roll size, incorrect tension adjustment, or misalignment. Adjust the wire feed rolls for the correct size and tension.
What to do if there is no gas flow in my Linde BOC Smootharc Advance MIG 200C?
If your Linde Welding System has no gas flow, or the gas flows continuously, the gas valve might be faulty or sticking in the open position. Test and replace the gas solenoid valve if it is faulty or sticking.
How to stop Linde Welding System connectors and lugs from overheating?
If you notice overheating of connectors and lugs on your Linde Welding System, it's likely due to loose or badly crimped connectors. Tighten or replace any loose or faulty connectors to fix this.
Why is there erratic wire feed in my Linde BOC Smootharc Advance MIG 200C Welding System?
If you're experiencing erratic wire feed or wire snarling at the outlet guide on your Linde Welding System, it may be due to a liner of incorrect type and size for the wire in use, or a worn, dirty, too long or too short liner. Replace the liner with the correct type and size to resolve this issue.
How to fix erratic or no output control on Linde BOC Smootharc Advance MIG 200C?
If you experience erratic or no output control with your Linde Welding System, the switches may be damaged or incorrectly set for the application. Check and replace any damaged switches, and ensure they are set correctly for your specific needs.
Why is my Linde Welding System torch overheating?
If the welding torch overheats on your Linde Welding System, it may be underrated for the welding application. Replace the welding torch with one that is appropriately rated for the specific welding application you are performing.
What to do if the arc will not initiate on a Linde BOC Smootharc Advance MIG 200C Welding System?
If the arc will not initiate on your Linde Welding System, inspect the earth cable and clamp for damage and ensure secure connections. Damaged, loose, or undersized cables and clamps can prevent arc initiation.
General| Input Voltage | 230V |
|---|---|
| Output Current Range | 30-200A |
| Duty Cycle | 200A@25% |
| Wire Feed Speed | 2-15 m/min |
| Wire Diameter | 0.6-1.0mm |
| Protection Class | IP21S |
To Next Page
