Controls & Connections
1•2
Gate Threshold – To adjust the threshold of the built-in Noise Gate, hold down the
Save and Ta p buttons and press the Left or Right button. See chapter 4 for more
info.
2
Display – This is where Pocket POD will tell you what’s going on. You’ll see things
like preset categories, preset names, control settings, Amp and Effect Model names, tuner
readings, etc.
3
Drive – This knob controls how hard you’re driving the input of a chosen Amp
Model, and just like the input volume control on a non-master volume guitar amp, higher
settings give you more “dirt.”
You can access the Bass tone control by holding down the Save button and turning
the Drive knob. When you change Amp Models, the response and interactivity of this
control changes. For example, when you select Black Panel, the tone controls operate like
the original amp that Model was based on*, the Fender
®
Deluxe Reverb
®
. This also goes
for the Mid and Treble tone controls described below.
4
Effects – This knob varies the effect you’ve chosen. Turn it up and the effect will
go deeper, louder, faster, longer or just plain more. To turn off the selected effect, turn this
knob all the way down. The speed of the effect (delay, tremolo, chorus, flanger, rotary
speaker simulation) is set by the Ta p button (described below). If you choose the Bypass
effect, the Effects knob will, of course, not change anything.
Hold down the Save button and turn the Effects knob to access the Mid tone control.
5
Delay – If you’ve chosen the Delay effect or a combo effect with delay, this knob
sets the mix level of the Delay; left for min and right for max. If you’re running a non-delay
effect, turning this knob automatically loads the corresponding combo effect, then sets the
mix level of the Delay. This knob doesn’t do anything when you choose the Rotary effect.
See Chapter 4 for more info.
Hold down the Save button and turn the Delay knob to access the Treble tone
control.
6
Chan Vol – This knob controls the relative volume level of the “channel” you are
playing through. Use this to balance levels between the sounds you store in the different
Pocket POD memory locations. In general, you want to set the Chan Vol as high as
* All product names are trademarks of their respective owners, which are in no way associated or affiliated with Line 6.
These product names, descriptions and images are provided for the sole purpose of identifying the specific products that were
studied during Line 6’s sound model development. FENDER
®
and DELUXE REVERB
®
are registered trademarks of
Fender Musical Instruments Corporation.
To Next Page
Loading...
Need help?
General
