5.5.12 Both faces meas............................................................................................53
5.5.13 Save Mode.....................................................................................................53
5.5.14 BACKSIGHT SAVE....................................................................................53
7.MEASURE............................................................................................................................81
7.1 Rectangular Coordinates..........................................................................................81
7.2 Polar Coordinates.....................................................................................................82
7.3 Rectangular & Polar Coordinates...........................................................................84
7.4 IH measurement........................................................................................................86
8. STAKE OUT.......................................................................................................................89
8.1 Stake Out...................................................................................................................89
8.2 Point to Line..............................................................................................................94
8.3.1 Three point...................................................................................................100
8.3.2 Circle radius.................................................................................................103
9. FILE MANAGER.............................................................................................................105
9.1 Information of the remaining memory availability.............................................105
9.2 Creation of a new Job.............................................................................................105
9.3 Selection of a Job Name..........................................................................................106
9.4 Deletion of a Job Name...........................................................................................106
9.5 All Clear...................................................................................................................106
10. VIEW AND EDIT...........................................................................................................107
10.1 Create the Rectangular Point..............................................................................107
10.2 Edit the Data..........................................................................................................108
10.3 Point Code List......................................................................................................109
10.3.1 Point Code...................................................................................................109
10.3.2 PointCode Create.......................................................................................111
10.3.3 PointCode Edit...........................................................................................111
11. FREE STATIONING.....................................................................................................112
11.1 Station setup [By Rectangular Coordinates]......................................................112
11.1.1 Coordinates, X, Y, Z, IH, and PC input...................................................113
11.1.2 Point selection from the list.......................................................................114
11.1.3 Station Orientation....................................................................................116
11.1.4 Multiple Orientation..................................................................................117
11.2 Station setup [By Polar Coordinates]..................................................................118
11.2.1 Point Name input.......................................................................................118
11.2.2 IH, TEMP, PRESS, ppm and PC input...................................................118
11.2.3 Station Orientation....................................................................................119
11.3 FREE STATIONING...........................................................................................120
11.3.1 Stationing by more than 3 known points.................................................120
11.3.2 Stationing by two known points..............................................................122
5
To Next Page
Loading...
Need help?
General
