Link Controls STAW 1-10-24 - General Safety Instructions

2 – Door Operator / STA / LC- 2973 Rev.H
1. Contents 3. General safety instructions
2. Key to symbols
Guarantee
The function and safety of the equipment is only guaranteed
if the warning and safety instructions included in these
operating instructions are adhered to.
Link Controls is not liable for any personal injury or damage
to property that occurs as a result of the warning and safety
instructions being disregarded.
Link Controls does not accept any liability or warranty for
damage due to the use of non-approved spare parts and
accessories.
Using the equipment for its intended purpose
Operators of the STA range are designed exclusively for
opening and closing counter balanced sectional doors.
Operators of the CDO range are designed exclusively for
opening and closing roller shutter doors (complete with
installation of a safety brake as required)
Target group
Only qualied and trained specialists are permitted to install
and service the operator. Qualied and trained professionals
full the following requirements:
- knowledge of the general and specic safety and accident
prevention regulations,
- Knowledge of the relevant regulations,
- trained in the use and care of appropriate safety equipment,
- Capable of recognising the dangers associated with
installation.
Only qualied and trained electricians may connect the
operator and carry out electrical maintenance.
Qualied and trained electricians full the following
requirements:
- knowledge of the general and specic safety and accident
prevention regulations,
- knowledge of the relevant electrical regulations,
- trained in the use and care of appropriate safety
equipment,
- capable of recognising the dangers associated with
electricity.
Instructions for installation and connection
- The controls must be disconnected from the electricity
supply before carrying out electrical works. It must be
ensured that the electricity supply remains disconnected
during the works.
- Local protective regulations must be complied with.
- Mains cables and control cables must be laid separately.
1. Contents 2
2. Key to symbols 2
3. General safety instructions 2
4. Overview of products 3
5. Installation 4
6. Initial Operation 9
7. Emergency operation 13
8. Maintenance 15
9. EU Declaration of Conformity 16
Danger of personal injury!
The safety instructions must be
observed!
Warning! Danger to property!
The safety instructions must be
observed!
Information
Special information
OR
Reference to other sources of
information