Door Operator / STA / LC- 2973 Rev.H– 5
5. Installation
Mounting torque support bracket to Operator
1. Remove Plastic caps (if tted) from hollow shaft of the
operator.
2. Fix torque plate using the 4-o M8x20 bolts, 4-o M8
spring washers and 4-o M8 at washers.
Information:
Link Controls Ltd. constantly strives to
improve the quality of its goods and as
such reserves the right to replace/modify
products without prior notication. Any
examples given are inteded for guidance
only.
5.3 CDO100 Compact Operator - Flange Mount
Handing the operator
This operator is suitable for left or right hand installation.
The ange and shaft can be removed and tted on the
opposite side.
Assembley of the operator
1. Remove the plastic caps
(if tted from hollow shaft of the operator)
Torque Plate is
height adjustable
As viewed from
End Elevation
‘1A’ ‘1B’
1
1
2
To Next Page
Loading...
