133Programming mode
Operating Instructions
If you forget the PIN, the LINK 2800 DECT/GAP can only be reset by the
Customer Service department.
Factory setting: 0 0 0 0
3.2.12 Music on hold
Function Parameter Inputs
code
MOH 27 0 #
An external caller on hold hears no music on hold.
MOH 27 1 #
An external caller on hold hears music on hold.
Factory setting: 1
3.2.13 Blacklist
Function Parameter Mob. no. Inputs
code
Blacklist 40 1…8 0 #
The subscriber is not monitored by the blacklist.
Blacklist 40 1…8 1 #
The subscriber is monitored by the blacklist.
Factory setting: 0
Function Parameter Entry Inputs
code no.
Exclusion area 41 1…5
No.
max. 6
figures
#
Entry is stored.
12
3Programming mode
3.2.9 Flash time
Function Parameter Inputs
code
Flash time 23 0…255 #
The flash time can be changed according to line requirements, in
increments of 10 ms.
Factory setting: 27, which is equal to 270 ms
3.2.10 CLIP
Function Parameter Inputs
code
CLIP 24 0 #
Evaluation of number presentation (CLIP) is deactivated.
CLIP 24 1 #
Evaluation of number presentation (CLIP) is activated. The number
transferred is sent to the called handset.
Factory setting: 1
3.2.11 Changing the PIN
Function Parameter Inputs
code
PIN change 26 new PIN new PIN #
Access to programming mode can be protected using the four-digit PIN.
The PIN only needs to be entered if a new PIN has been set beforehand
in programming mode. To change the PIN, activate programming mode,
enter the new PIN twice and confirm this by pressing
#
. The change is
confirmed by the positive acknowledgement tone. Programming mode
can then only be accessed again by entering the new PIN once more. To
restore the factory setting, change the PIN to 0000.
To Next Page
Loading...
Need help?
General