Ethernet Configuration
This option allows you to choose the duplex and
speed performance of the HomeLink Card’s RJ-45
Ethernet port. In order to change the port settings,
the Mode Selection option must be set at 10BaseT
Only, or 10/100BaseTX Only, or the mode must
be set at Auto Detect with a valid link on the
10BaseT Port.
• 10Mbps Half Duplex sets the 10BaseT port to
half duplex mode. This is the default setting.
• 10Mbps Full Duplex sets the 10BaseT port to
full duplex mode.
44
Card Settings
To Next Page
Loading...