Mode Selection
You can set the HomeLink Phoneline Network
Card to default to either a 10BaseT connection or
Phoneline connection. Since there are three ports,
the card is set to Auto Detect an active connec-
tion. Auto Detect will look first for a connection
on the 10BaseT port, and if one is not found, the
card will default to the Phoneline connection.
You can configure the card to use only one con-
nection type.
• 10/100 Ethernet (External) mode will force the
card to use a 10/100 connection if one is present.
• 10BaseT Ethernet (Internal) mode will force
the card to use a 10Mbps connection if one is
present.
• Phoneline mode will force the card to use only
the 1Mbps Phoneline connection.
Card Settings
45
To Next Page
Loading...