Linksys LGS310C User Manual

LGS310C / LGS310MPC
LGS328C / LGS328MPC / LGS328PC
LGS352C / LGS352MPC
網管交換機快速入門指南
以太网交换机快速入门指南
Managed Switches
Quick Start Guide
Technical Support, Regulatory, Safety and Warranty
Information about Linksys Business Products can be found at www.linksys.com/support
2021 Linksys Holdings, Inc. and/or its affiliates. All rights reserved.
8820-03073 Rev. B00
Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply
a partnership relationship between Linksys or any of its affiliates and any other company.
To rack-mount the switch in any standard 19-inch wide, 1U high rack:
1) Place the switch on a hard flat surface with the front panel facing you.
Using the supplied screws, attach rack-mount brackets to either side of the switch and
secure tightly.
2)
Attaching the brackets
3)
Mounting in Rack
After the brackets are attached, use supplied screws to securely attach the brackets
to any standard 19-inch rack.
Rackmount Installation

Linksys LGS310C Specifications

General

Number of Ports	8
Layer	Layer 2
Power over Ethernet (PoE)	No
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Certifications	CE, FCC, RoHS
Manageable	Yes
Primary Ports	8
Port Type	Gigabit
MAC Address Table Size	8K entries
Jumbo Frame Support	Yes
Dimensions	44 mm
Weight	1.27 kg
Operating Temperature	0 to 40 °C
Storage Temperature	-40 to 70 °C
Humidity	10% to 85% non-condensing

Summary

Rackmount Installation

Package Contents

Product Overview

Power LED

Indicates switch power status: solid green for normal, blinking green for booting, off for no power.

Fault LED

Indicates hardware failure: solid amber for failure.

PoE Max LED

Indicates maximum PoE budget reached: solid amber for PoE SKUs.

Mode Button

Toggles Port LEDs between LAN and PoE modes.

LAN Mode LED

Indicates Port LEDs are set to LAN mode, showing Ethernet speed.

PoE Mode LED

Indicates Port LEDs are set to PoE mode, showing active PoE connections.

LAN Mode Port LED

Shows port speed in LAN mode: solid green for 1000 Mbps, off for 10/100 Mbps or no connection.

PoE Mode Port LED

Shows active PoE connections: solid green for power, blinking green for error, off for no power transmission.

Link/Act LED

Indicates port link status and activity: solid green for connected, blinking for activity, off for no link.

Reset Button

Reboots switch (short press) or resets to factory settings (long press).

Auto-sensing Ethernet Ports

Automatically adjust port speed and duplex for connected devices.

SFP/SFP+ Ports

For expansion modules, providing high-speed network uplinks.