10
Chapter 4: Connecting the Router
Overview
10/100 8-Port VPN Router
Chapter 4: Connecting the Router
Overview
To set up your network, you will do the following:
• Connect the Router to one of your PCs according to the instructions in this chapter.
• If necessary, configure your PCs to obtain an IP address automatically from the Router, according to
“Appendix G: Windows Help”. (By default, Windows 98, 2000, Millennium, and XP computers are set to obtain
an IP address automatically, so unless you have changed the default setting, then you will not need to
configure your PCs.)
• Set up and configure the Router with the setting(s) provided by your Internet Service Provider (ISP) according
to “Chapter 5: Setting up and Configuring the Router.”
The installation technician from your ISP should have left the setup information with you after installing your
broadband connection. If not, you can call your ISP to request the information. Once you have the setup
information for your specific type of Internet connection, then you can begin installation and setup of the Router.
10/100 8-Port
VPN Router
Notebook with
Ethernet Adapter
PC with Ethernet
Adapter
Cable or DSL
Modem
Figure 4-1: Example of a Typical Network
Broadband: an always-on, fast Internet connection
To Next Page
Loading...
Need help?
General
