17
Chapter 5: Setting Up and Configuring the Router
System Summary Tab
10/100 8-Port VPN Router
Firewall Setting Status
SPI (Stateful Packet Inspection): This shows if the SPI status is On or Off, hyperlinked to that section of the
Firewall Tab.
DoS (Denial of Service): This shows if the DoS status is On or Off, hyperlinked to that section of the Firewall Tab.
Block WAN Request: This shows if the Block WAN Request status is On or Off, hyperlinked to that section of the
Firewall Tab.
VPN Setting Status
VPN Summary: This hyperlink will take you to the Summary page of the VPN Tab.
Tunnel(s) Used: This displays the amount of VPN Tunnels used.
Tunnel(s) Available: This displays the amount of VPN Tunnels available.
Current Connected (The Group Name of GroupVPN1) users: This displays the amount of VPN users connected
via GroupVPN1.
Current Connected (The Group Name of GroupVPN2) users: This displays the amount of VPN users connected
via GroupVPN2.
(If GroupVPN is disabled, it will show “No Group VPN was defined.”)
Log Setting Status:
This hyperlink will take you to the System Log page of the Log Tab.
If you have not set up the Log’s mail server, this will show “E-mail cannot be sent because you have not specified
an outbound SMTP server address.”
If you have set up the mail server but the log has not come out due to Log Queue Length and Log Time Threshold
settings, this will show “E-mail settings have been configured.”
If you have set up the mail server and the log has been sent to the mail server, this will show “E-mail settings
have been configured and sent out normally.”
If you have set up the mail server and the log cannot be sent to mail server successfully, this will show “E-mail
cannot be sent out, probably use incorrect settings.”
To Next Page
Loading...
Need help?
General
