14. After setting the Properties fields, Windows NT will begin installing the
network components you previously selected. You may be asked if you
would like to configure the protocols with a DHCP server on your network.
If this screen comes up, check with your Network Administrator before
clicking the Ye s or No button to continue.
15. After the network component installation is complete, the following screen
may appear. Click the Next button to continue.
16. At this point, Windows NT will let you know that it is ready to start the net-
work. If you wish to make any corrections, click the Back button. To con-
tinue, click the Next button.
20
12. Windows NT may
request further files
at this point. Type
“ D:\WPC11-
WDT11\WINNT”
in the field provid-
ed and click the
Continue button.
If files are still
requested, insert
your Windows NT
CD into your CD-
ROM drive and
type “D:\i386”
(where “D” repre-
sents your CD-
ROM drive). Then,
click the Continue
button.
13. You will now reach the
screen shown here. This is
called the Properties
screen. Please check with
your other wireless com-
puters for the proper set-
tings. For more informa-
tion concerning these set-
tings, refer to the section
called Configuring the
Network PC Card for
Windows NT. Adjust the
settings as are appropriate
and click the OK button.
19
Network PC Card and PCI AdapterInstant Wireless
TM
Series
To Next Page
Loading...
