Linksys WRT350N - The Storage Tab - FTP Server; Figure 5-38: Storage Tab - FTP Server; Figure 5-39: FTP Access

36
Chapter 5: Configuring the Wireless-N Gigabit Router with Storage Link
The Storage Tab - FTP Server
Wireless-N Gigabit Router with Storage Link
The Storage Tab - FTP Server
Use the FTP Server screen to configure the Router as an FTP server for your local network.
FTP Server
Setup
Server Name. The name of the Router is displayed here.
FTP Server. Select Enable to use the Router as an FTP server. Otherwise, select Disable. (A USB flash drive or
USB hard disk must be connected to the USB port to use this feature.)
Internet Access. Select Enable to allow access to the FTP server from the Internet. Select Disable, to restrict
access to the FTP server to local users only (from your local networked computers only).
Port. Select the port number to use. The default port is 21.
Share
Select the partition(s) or folder(s) to share through the FTP server.
All Partitions. Selects all partitions on the USB disk.
Specify Folder. If you want to share a specific folder, click Select Partition and locate the folder.
When you have finished making changes to this screen, click the Save Settings button to save the changes, or
click the Cancel Changes button to undo your changes. Help information is available on the right side of the
screen.
Access
Click the FTP Share Access button to grant specific rights to groups. You can grant Read Only or Read/Write
permission.
On the FTP Access screen, select the appropriate group from the Other Group column and click either the Read
Only or Read/Write button to move the group to the Group With Access column.
After you have made your changes, click the Save Settings button to apply your changes, or click the Cancel
Changes button to undo your changes. Click the Close button to exit the FTP Access screen.
Figure 5-38: Storage Tab - FTP Server
Figure 5-39: FTP Access