Linksys WRT350N User Manual

52
Chapter 5: Configuring the Wireless-N Gigabit Router with Storage Link
The Status Tab - Router
Wireless-N Gigabit Router with Storage Link
The Status Tab - Router
The Router screen displays information about the Router and its current settings. The on-screen information will
vary depending on the Internet Connection Type selected on the Setup screen.
Router Information
Firmware Version. This is the version number of the Router’s current firmware.
Current Time. This shows the time set on the Router.
Internet MAC Address. This is the Router’s MAC address, as seen by your ISP.
Host Name. If required by your ISP, this was entered on the Basic Setup screen.
Domain Name. If required by your ISP, this was entered on the Basic Setup screen.
Internet Connection
Connection Type. This indicates the type of Internet connection you are using. For dial-up style connections such
as PPPoE or PPTP, there is a Connect button to click if there is no connection and you want to establish an Internet
connection.
Internet IP Address. The Router’s Internet IP address is displayed here.
Subnet Mask and Default Gateway. The Router’s Subnet Mask and Default Gateway address are displayed here
for DHCP and static IP connections.
DNS1-3. Shown here are the DNS (Domain Name System) IP addresses currently used by the Router.
MTU. Shown here is the MTU (Maximum Transmission Unit) setting for the Router.
DHCP Lease Time. Displays how long the lease is for the IP address that your ISP automatically assigned you.
IP Address Release. Available for a DHCP connection, click this button to release the current IP address of the
device connected to the Router’s Internet port.
IP Address Renew. Available for a DHCP connection, click this button to replace the current IP address—of the
device connected to the Router’s Internet port—with a new IP address.
Click the Refresh button to update the on-screen information. Help information is available on the right side of
the screen.
Figure 5-62: Status Tab - Router

Linksys WRT350N Specifications

Standards and Ports

standards	Draft 802.11n, 802.11g, 802.11b, 802.3, 802.3u, 802.3x, 802.3ab, USB 2.0
ports	Power, Internet, Ethernet, USB
cabling type	CAT 5e, USB 2.0

Antenna Specifications

number of antennas	3
RF power (EIRP)	17 dBm
antenna gain	1.8 dBi

Power

power voltage	12V
power current	1.5A
power adapter	Included

Operating Environment

operating temperature	0 to 40°C
storage temperature	-20 to 60°C
operating humidity	10 to 85% non-condensing

Weight and Dimensions

weight	520 g
dimensions	188 x 40 x 176 mm
device dimensions	188 x 40 x 176 mm