Connection Control
This screen allows you to configure the Connection Control List to either permit or block
specific wireless client devices connecting to (associating with) the Wireless Router.
Wireless Connection Control
Select SSID. Select the desired SSID.
Enabled
/
Disabled
. Enable or disable wireless connection control. The default is
Disabled.
Connection Control
There are two ways to control the connection (association) of wireless client devices. You
can either prevent specific devices from connecting to the Wireless Router, or you can
allow only specific client devices to connect to the Wireless Router. The client devices
are specified by their MAC addresses. The default is to allow only specific client devices.
Wireless Client List
Instead of manually entering the MAC addresses of each client, the Wireless Router
provides a convenient way to select a specific client device from the client association
table. Click this button and a window appears to let you select a MAC address from the
table. The selected MAC address will be entered into the Connection Control List.
To Next Page
Loading...
