WDS
On this screen you can configure the WDS (Wireless Distribution System) settings for the
device.
WDS MAC Address. It displays the read-only MAC address for the WDS.
Allow wireless signal to be repeated by a repeater. Select Auto or Manual as required.
Remote Access Point’s MAC Address. You can either enter the MAC address directly,
or, if the other AP is on-line, you can click the Site Survey button and select from a list
of available APs.
Change these settings as described here and click Save Settings to apply your changes, or
click Cancel Changes to cancel your changes. Help information is displayed on the
right-hand side of the screen.
To Next Page
Loading...
