Linn AXIS - Page 5

PERATION The switch on the Axis provides a trigger to the
electronics to start or stop the motor. It does not break any mains
-*s<-connection. Power remains on the circuit board all the time. Static
power consumption is very low.
After connection, the circuitry should be given a few seconds to settle before
switching the motor on.
Speed selection
33 rpm: The Axis has an electronic speed change. To engage 33 rpm press
switch once and the red LED will light, indicating 33rpm. To stop press
switch once again.
45rpm: Press and hold switch. Red LED will light, then green, indicating
45rpm. To stop, press switch once again. NOTE: If the platter is deliberately
stopped whilst operating at 45rpm, the turntable will not automatically
re-start. To re-start it is necessary to switch off the turntable, wait a few
seconds and select speed*
Note that when mains is first applied the turntable may rotate at 33 or
A5rpm. This is normal and is not a cause for concern.
*Note: The platter will take about 8 seconds to fully reach 45rpm.