Linn AXIS - Page 7

gag ENERAL SYSTEM INSTALLATION
TRACKING WEIGHT AND BIAS: Every arm and cartridge combination has
an optimum tracking weight. This is best set by listening. Increments of
0.1g can produce significant differences. Test records are of no use in
establishing tracking weight and bias. Temperature can alter these values,
which will be lower in hot weather and higher in cold weather. Note: On Linn
arms, the bias should be set at the same value as the tracking weight.
RECORD CLEANING: Most record cleaning devices do more harm than
good. The best method of cleaning records is to let the stylus remove any dirt
which may be in the groove, then clean the stylus.
STYLUS CLEANING: It ts important that the stylus is kept scrupulously clean.
We have found that dry vibrating pad cleaners work well. Alternatively, Linn
dealers can supply stylus cleaning paper which Is easy to use and gives
excellent results.
CLEAN CONTACTS: Electrical contacts in a hifi system must be kept
mechanically sound and clean. A poor contact between the cartridge and
arm will degrade performance. Checks on all contacts should be performed
periodically.
INTERCONNECT LEADS: We recommend and supply good quality copper
cable for interconnect leads and advise 20 amp multicore copper cable for
speaker leads.
SPEAKER PLACEMENT: Speakers should be positioned correctly and
should be mounted on rigid stands which are sitting firmly on the floor and
not rocking. Note: Linn speakers are designed to be placed close to the wall.