Linn AXIS - Page 8

RANSPORTATION Always keep all the packing for your Axis
turntable.
a= sam
When transporting the Axis turntable, remove the counterweight
from the arm, remove the inner platter from the bearing housing and place it
Lid se re ee
in its position in the packing. Replace the bearing cap to prevent ail spillage.
miaeek If the deck is to be shipped anywhere, then it is important to follow these
infer Platter \ instructions:
Tonearm = fo de (IK Mains Lead =» - Remove mains lead and place in top tray.
Kg : © - Remove lid and place hinges in top tray.
— Remove outer platter. Remove belt and place around the centre hub in
bottom packing tray.
— Place platter and felt mat in position in bottom packing tray.
~ Fit stylus guard, remove arm counterweight, disconnect arm cable
Phono Plugs (if necessary, loosen the lockscrew}, loosen arm height adjusting screw,
Support
Tray
Ez
\
and
remove
tonearm.
Place
arm
and
counterweight
in
their
respective
Felt
Mac
=
slots
in
top
packing
tray.
Outer
Platter
Belt ~ Remove inner platter and place in top tray. Insert foam packing strips
between plinth and top-board. Insert transit screw through hole in
baseboard into its thread and tighten until top board is held firmly.
Bottom
Packing Tray
— Place turntable in position on polystyrene plinth support tray, with the
polystyrene spacing piece in place. Arm cable should be wrapped round
the 3 suspension feet. Secure the phono plugs on to the base of the plinth
with a piece of tape.
~ Place top tray over turntable, place cardboard spacer on top. Lid should be
put in its plastic bag and fitted into slot in top tray.
— Place polystyrene spacer on top of lid and close box.