Contents
15
Switch off the entire Knekt system from one RCU.
There is a facility, with Intersekt, that will power off the entire Knekt system. To actually
disconnect power from the whole system each Room would require a Relay Boks. If there
is no Relay Boks then the Power Down command will put every Room into ‘MUTE’ by
turning all RCU’s in the Knekt system ‘off’.
Press and HOLD the ON/OFF switch on the RCU. The RCU display will count down, 5-
4-3-2-1, and shutdown the full system (Disconnect all sources from ALL rooms!).
There is NO global power on facility. Each Room will revert to it’s previous state when
that Room’s RCU is switched ‘on’.
Switching ON the Intersekt.
With an Intersekt system with RER16 and SES8 make sure that you switch on the SES8
FIRST. Otherwise the SES8 doesn’t now what Sources are IR controlled, it assumes that
every source is a Linn source (which it should be guv!).
Switching OFF the Intersekt system.
Make sure that every RCU is in Stand-by mode. If the RCU is getting a Source STATUS,
the Intersekt is too busy waiting for the RCU to finish it’s task and sometimes doesn’t
have enough time to go into Standby itself. This can cause the Intersekt to loose its
memory and has to be re-setup
To Next Page
Loading...