Contents
20
Controlling 58kHz Devices with an Intersekt system.
For some of the Satelitte recievers, it is necessary to output with a IR carrier frequency of 58kHz. The
extra equipment required is a Knekt Line Driver and a Doubri (RJ45 to Phono Convertor).
Conversion of the Line Driver.
The following change below is required:-
1. Short out R302.
2. Bridge resistor R301 with a resistor of 470Ω.
3. Adjust Vr301 for approx 58kHz, (U301 pin 3). This step done while transmitting the code.
Changes required with Linstall.tpl file
DEVICE “RCADSS”
LIBRARY “rcadss”
FEATURE LINN
MODES“Unused”, “Unused”, “Prog Select”, “Unused” , “Unused” , “Unused” , “Unused” ,
“Unused”,”Standby”
TYPE Satellite
END DEVICE
The Line in BOLD ITALICS is to be ADDED
Connecting Intersekt to Line Driver.
Connection is made from the Remote out socket on the Intersekt to the Red Sockets (Remote In) on the
Doubri using the Phono lead. Then using the 8 way cable from the Doubri to the Accessories socket on the
Line Driver.
To Next Page
Loading...