Linn Intersekt Stuff - Main System Sources Can be Controlled Independently

Contents
4
Main System sources can be controlled independently.
A Line Driver based system transmits all control commands to ALL Main System sources,
e.g. a [ PLAY ] command will be sent round the entire Linn Line Remote Loop AND
echoed from each IR repeater output.
This will only present a problem if a customer has, for example, 2 Kremlin tuners or 2
generic RC5 CD players or 2 VCR’s.
( Remember: In a Line Driver based Knekt system a Linn AND a non RC5 source of
the same type will not have this particular problem. e.g. a Karik and a Pioneer CD
player ).
With an Intersekt, each source is controlled independently: commands for Tuner 1 are sent
ONLY to Tuner 1, commands for Tuner 3 are sent ONLY to Tuner 3. Each source input
on an Intersekt has a corresponding set of control i/p o/p sockets.
For a Linn source, commands are sent and status is read back via two phono sockets
connected to the Linn Line Remote sockets on each individual Linn source.
For a non-Linn source, commands are sent via one phono socket (and a phono to 3.5mm
adapter ) to the IR repeater for that particular source.
The wee adapter....
RS part nr 177-734 app 47p
Tandy ( Radio Shack ) have them as well.