User-Settable F-Function List
This feature allows you to take the 28 F-Functions that currently reside in each
MTH Proto-Sound 3.0-equipped O-Gauge Engine and change the location of that
function. For example: F4 is currently PFA and you'd like that placed down to
F28 which is Feature Reset. The below instructions explain how you can do this.
Note – When you set a particular F-Function to a numeric location you are
overwriting that existing number's function. Further, you are leaving the location
where the previous function was moved from empty, which means that F-
Function no longer has any function associated with it
In order to move the F-Functions around you will need to refer to the below
table.
Note – The Function Identification number IS NOT the F Function number
you'd use on your DCC handheld. It is used internally in the engine:
SOUNDS
Bell
Brake Sounds
Cab Chatter
Clickety Clack
Coupler Close
Coupler Slack
Drift Chuff
Engine Sounds
Forward Signal
Grade Crossing Signal
Horn
Idle Sequence 1
Idle Sequence 2
Idle Sequence 3
Idle Sequence 4
Labor Chuff
Master Volume
Short Horn
One Shot Doppler
Reverse Signal
SCRIPTS
Extended Shut Down
Extended Start Up
PFA
Start Up/Shut Down
Train Wreck
Trolley Manual Mode
Trolley Learn Mode
Trolley Auto Mode
FUNCTION
IDENTIFICATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
Function Identification Chart
OTHER FUNCTIONS
Feature Reset
Front Coupler
Front Pantograph
Up/Down
Pantograph
Auto/Manual
Rear Coupler
Rear Pantograph
Up/Down
Rev Down
Rev Up
Smoke On/Off
Smoke Volume
LIGHTS
Lights
FUNCTION
IDENTIFICATION
29
30
31
32
33
34
35
36
37
38
39
Lionel Corporation No. 255, 260 & 263 Steam Engines with Proto-Sound® 3.0
26
To Next Page