8
Figure 3. Smoke fluid locations
Locomotive set operations
The non-powered unit is not equipped with a smoke generator. Do not add smoke fluid to
the non-powered unit.
Y
our powered locomotive is equipped with a smoke generator that produces safe, clean, white
smoke during operation. Add 10-20 drops to the stack (shown in Figure 3) to prime the unit the
first time you run the locomotive or after being stored for an extended period of time. Add 10 to 20
drops to refill when smoke production decreases.
When refilling, DO NOT EXCEED 20 DROPS as this can cause your smoke unit to become
oversaturated allowing leakage onto the electronics. Note that operating your locomotive's smoke
unit without smoke fluid will cause damage to the heating element.
If you prefer to operate your locomotive without smoke, locate the smoke unit switch and slide it
to the NO SMK position. Refer to Figure 1 on page 5 for the location of the switch.
For best performance, we recommend using Lionel smoke fluid only.
Adding smoke fluid to your powered locomotive’s smoke generator
Note!
Note!
Add smoke fluid here (no
more than 10 to 20 drops)
To Next Page
Loading...
