Lionelo Otto - How to Replace a Battery; How to Use the Product

‑ 7 ‑ EN
3. Li frames of the seat (5) and then put the fabric covering on it (g. 3). Fasten the
Velcro at the boom of the covering.
How to replace a baery
1. Use a screwdriver to loosen the bolt which secures the baery compartment
(g. 4).
2. Remove the battery cover and insert four LR14 batteries in the
compartment. Pay special attention to battery poles (see: fig. 5).
It is advisable to use alkaline baeries.
3. Put the baery cover on and ghten up with a screwdriver. Do not ghten
up too rmly (g. 6).
Feeder cable
To use the mains power supply, connect a USB cable to the sound module of
the baby swing (port marked as e in g. 13). Insert the second p in the relevant
mains power adapter (not supplied).
Note! The feeder cable should have the following parameters:
input: 100-240V ~ 50/60Hz 0.3A, output: 5V
1000mA.
How to use the product
Cushion – the product is equipped with a high-quality cushion which can be
aached to the covering with a Velcro (6) located underneath the cushion. To
do so, pull the cushion Velcro through a fastening which stands out from the
seat (g. 7) and fasten it.
5 – point safety belts - when the child is in the baby swing, safety belts must
always be fastened.
A. To fasten the belts:
1.
Put the child into the baby swing. Make sure your child’s legs go through
the protecve fabric cushion, as presented in g. 11.
2. Insert the p of shoulder belts (A in g. 8) in hip belts (B in g. 8). Pull child’s
hands through them.
3. When the belts are connected, insert them in the buckle (C in g. 8). If you can
hear a „click”, it means the assembly has been successful.
4. Aer you have fastened the belts, put the protecon on the buckle (g. 9).