Lionelo Otto - Troubleshooting

‑ 9 ‑ EN
2. Disconnect the control module from the baby swing. frame and then li it.
3. Connect the legs of the product.
4.
Secure the product with an assembly belt located at the reverse of the
covering (see: g. 15)
Troubleshoong
Problem Possible cause Soluon Addional informaon
Light indicator
ashes
Low baeries
or damage to
feeder cable.
Replace baery or
adapter.
Rocking stops
suddenly.
Set me has
passed.
Deacvate rocking
with a knob and
then acvate it
again. Disable
rocking me seng.
Each of these soluons
will cause the product to
resume working, only the
following will change: work
me and rocking speed.
Rocking does
not start
Baeries have
been inserted in
a wrong way.
Damage to the
feeder cable.
Feeder cable
has been connected
in a wrong way.
No power supply
in the socket.
Insert the baeries
again. Pay special
aenon to marking
(poles).
Check the feeder
cable and wire for
proper connecon.
Check if the feeder
cable has been
plugged in the
socket properly.
The angle of
rocking is lower
than desired.
The baby swing
needs about
20-45 seconds
to rock properly.
At low voltage and high
load, the baby swing may
need up to 50 seconds to
start rocking properly.
Distorted music. Flat baeries.
Replace the baeries.