Removing the 5-point safety
harness
Installation of the 5-point safety harness
Make the straps as loose as possible and
open the harness buckle.
Remove one of the connectors
from the safety strap.
Check the position of the three
harness connectors under the safety
seat.
Then, pull out the strap from the safety
seat. Repeat the step above for the other
connectors.
Make sure that the safety seat cover
is properly installed. Run the straps
through the proper holes and lock
them with the metal connectors.
Ensure that all the connectors and
straps have been properly installed
and secured.
Ensure that the straps are not
twisted.
Put one shoulder pad on each of the
two shoulder straps, anti-slip side
facing inwards.
Remove the two shoulder straps from the
harness connector at the back of the
safety seat.
Pull the straps out of the safety
seat.
Choose a desirable height and slide
the straps through the corresponding
holes.
Insert the two shoulder straps into
the connector at the back of the
safety seat. After all these steps the
installation is finished.
To Next Page
Loading...
